Our facade stripper effectively removes all paints, stains and varnishes, even the most stubborn ones on the facade. Paraffin-free and with a very low odour, it is ready to use. While competing products no longer work after a maximum of two hours, it remains active for up to 3 days.
Application temperature: above +5°C.
Yield: 0.4 to 0.8 liters per m².
Non-flammable, non-corrosive.
PROPERTIES:
Without methylene chloride.
Gel stripper, does not run even on vertical walls.
Paraffin free, odourless, ready to use.
Removes even stubborn layers.
Active for up to 72 hours.
Non-corrosive.
Applicable in airless projection.
Inside and outside.
Deep stripping.
Non-flammable.
Does not darken the wood and does not attack the glass.
DESTINATION:
• Designed for all types of facades.
• Eligible materials: single-component organic building paints, thin films, plasters, thick and semi-thick plastic coatings, external thermal insulation, I3 and I4 waterproofing coatings.
RECOMMENDATIONS:
• The support must be dry and perfectly cleaned. Scratch the paint beforehand if necessary, to facilitate the action of the stripper.
TIPS:
• Doing a test before application allows you to know exactly the time of action of the stripper on the surface to be stripped and thus optimize your time and effort.
• On a surface of 20 cm², apply a thick layer then let the product react. Observe the stripper's work. Make a partial scraping over time to compare the result.
APPLICATION:
• Using a brush or any other airless spray equipment, apply a thick layer. Leave to act between 4 and 24 hours, or even up to 72 hours, depending on the nature of the coating and the load.
• The action time may also vary depending on the temperature or wind conditions. To limit premature drying caused by the wind or high temperature, it can be covered with a plastic film.
• Scrape with a spatula or a scraper then wash with hot or cold water, with a high pressure cleaner, minimum 120 bars, with a water flow rate of at least 800 liters per hour.